Skip to main content

Care and Caution

Handling​

  • Handle the Antares 4G with care. Avoid dropping or subjecting it to strong mechanical shocks.
  • Do not open or attempt to repair the device. There are no user-serviceable parts inside.
  • Keep the device clean and dry. Use a slightly damp cloth for cleaning if necessary.

Electrical Safety​

  • Ensure the power supply voltage is within the specified range before connecting the device.
  • Never connect or disconnect the device while power is applied to the harness connector.
  • The digital outputs (XP1, XP2) are open-collector type. Do not exceed their rated current or voltage.
  • Input detection thresholds: Active state = 0 V to 2 V; Inactive state = > 2.5 V. Do not apply voltages outside the rated range.
  • Over-temperature protection on outputs activates at 165 °C.

Installation Environment​

  • Install the device in a location protected from direct water spray, condensation, and extreme temperatures.
  • Avoid mounting near sources of strong electromagnetic interference (ignition coils, high-voltage cables).
  • Ensure adequate ventilation around the device.
  • Secure all cables and connectors to prevent vibration damage.

Firmware Updates​

  • Do not interrupt power during a firmware update. An incomplete update may render the device unresponsive.
  • Use only official firmware packages from DCT.

Regulatory​

  • This device must be installed and operated in accordance with all applicable local regulations.
  • The device is intended for use in vehicles and fixed assets. Do not use it in applications where failure could cause injury or loss of life without appropriate safety interlocks.
  • Dispose of the device according to local electronic waste regulations. Do not discard in regular trash.

FCC / Regulatory Notice​

caution

Changes or modifications not expressly approved by Digital Communications Technologies (DCT) could void the user's authority to operate this equipment.